Polaris General Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
Installed it today was pretty easy task, it looks great and works even better. I was worried about the latch not holding it closed but it's so tight i have a hard time unlatching it and that's a good thing !
The fit and finish is pretty good.
 

Attachments

·
Super Moderator
Joined
·
4,175 Posts
Looks good!
Is a three position like all the others closed / vent open and full open?
 

·
Registered
Joined
·
3,689 Posts
Nice pics, good job!
How hard was it to install and how long did it take? Have to take out radio?
 

·
Registered
Joined
·
1,314 Posts
Yes the 3 position. I had very hard time unlatching specially in the 4" open position I made a forked opener out of wood that fits under both sides to lift up. I carry it in my center console I have hers of guys sanding with a dremel but I wanted to keep it tight.
 

·
Registered
Joined
·
30 Posts
Discussion Starter · #6 ·
It took a couple hrs and i wasn't hurrying, you have to remove the top and radio but it was easy to do.
Keep track of where the long screws go vs shorts if you do this :)
I also rain-xed it too.
 

·
Registered
Joined
·
145 Posts
It took a couple hrs and i wasn't hurrying, you have to remove the top and radio but it was easy to do.
Keep track of where the long screws go vs shorts if you do this :)
I also rain-xed it too.
Thats the same one I have and I love it! I have not scratched it yet. And it has been used for a couple thousand miles! I did think the shocks were sagging a bit so the sent me a newer updated set that they say can handle rougher riding. I really like the quality and value of their products.
 
1 - 8 of 8 Posts
Top