Polaris General Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
100 Posts
Discussion Starter #1
I installed Rhino 2.0 front and rear axles. They seemed to fit ok. The only question I have is the front axles taper a bit before the splines that go into the front transmission? This leaves a bit of a gap between the taper and the main axle housing. The rears don't do this and appear to fit perfectly into the Polaris cutout.

Why are the fronts different?

It makes me wonder if I have the correct axles for the front?
 
1 - 3 of 3 Posts
Top