Polaris General Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
I knew that I wanted to add a rear bumper but couldn't find one I liked. So I made an attempt to build one (I am not a machinist or metal fabricator or anything remotely close to a metal worker) but I thought I would take a stab at it. Would like comments to try to help improve myself with future metal projects for my General..
20210104_192221.jpg 20210108_192911.jpg 20210108_192926.jpg 20210108_192934.jpg 20210108_192941.jpg 20210108_192950.jpg 20210108_193008.jpg
 

·
Registered
2020 General 4 1000, SuperATV 3” lift, Quad Boss 2” wheel spacers, Hunterworks rollers and belt
Joined
·
230 Posts
Looks good. I think you did fine!👍
 

·
Registered
Joined
·
196 Posts
For your 1st stab at fabrication looks like you done a great job. Looks good.
 
  • Like
Reactions: Drewdogg437

·
Registered
Joined
·
3,035 Posts
Congrats on that and it looks good.
Welcome to the Forum.
 
  • Like
Reactions: Drewdogg437

·
Premium Member
Joined
·
1,447 Posts
Looks great, nice job!
 
  • Like
Reactions: Drewdogg437

·
Registered
Joined
·
6 Posts
Discussion Starter #11
That is the best I've seen. Clean and sturdy. Nicely done. Did you powder coat it? What are the vertical lites for?
I used epoxy paint but it was too glossy so I used a rubberized coating on it. Looks way better. The vertical lights are my backup lights.(More of an indicator light that a seeing light)
 
1 - 14 of 14 Posts
Top