Polaris General Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
85 Posts
Discussion Starter #1
When wiring up an accessory with a relay and rocket switch. How are you guys attaching your ground wire from the switch to the relay and then back to the bus bar? Are you crimping two wires together into the female spade terminal on the relay or are you using some sort of piggy back spade terminal? I understand wiring somewhat but I don’t know what’s all out there in terms of what would be the best way to attach all the grounds in a clean fashion back to the bus bar
 

·
Registered
Joined
·
108 Posts
I ran both the switch and relay ground into one butt connector and hook the other side to the pulse ground
I also "piggy back" them in to each other when a small draw is needed
All these grounds do is power the LEDs in the switches
And all the switches do is turn on the relays so small wires are ok

Sent from my Moto Z (2) using Tapatalk
 

·
Registered
Joined
·
85 Posts
Discussion Starter #4
I guess my question is how do I run the three ground wires: one for accessory, one for switch, and one for relay all back to the bus bar in the cleanest way
 
1 - 4 of 4 Posts
Top