Polaris General Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
69 Posts
Discussion Starter #1
Hey guys I got to take a new general for a test ride today. What are u guys doing about the dash vibration at low speeds. It was vibrating so much u could see the top half separate from the bottom half.
 

·
Senior Member
Joined
·
1,560 Posts
My dash has a piss poor fit. Tabs don't reach the holes.
 

·
Senior Member
Joined
·
1,560 Posts
I am waiting on my glass windshield system to get in before I assemble everything. I have It torn apart for the heater install. I'm thinking one of the things I will look at is the thin sticky back weather stripping along areas that make contact with the lower dash. I used some on the heater where the manifold attaches to the heater to seal the 2 surfaces. Use the thin stuff. Any hardware store should carry it.
 

·
Senior Member
Joined
·
1,560 Posts
As far as the clips not reaching the holes in the center of the dash I'm not sure yet.
 
1 - 5 of 5 Posts
Top