Polaris General Forum banner

21 - 24 of 24 Posts

·
Registered
Joined
·
36 Posts
Tusk utv heater

Sent from my Moto Z (2) using Tapatalk
Thanks!
Did you use the pulse bar for switched power?
If so, does each seat heater take up a slot ,or did you put 2 or 4 seats per Pulse plug?
 

·
Registered
Joined
·
107 Posts
Discussion Starter #22
Thanks!
Did you use the pulse bar for switched power?
If so, does each seat heater take up a slot ,or did you put 2 or 4 seats per Pulse plug?
I have just started the install only one seat done and the base has middle velcro that I kind of ignored seems like it will be ok just doesn't sit low in middle as it did
Will have base pictures tomorrow
Probably not going to wire anything till I'm done but I think I'll run them all thru 1 depending on draw


Sent from my Moto Z (2) using Tapatalk
 

·
Registered
Joined
·
1,005 Posts
Curious to see how this works out for you!
 

·
Registered
Joined
·
107 Posts
Discussion Starter #24
So I haven't finished any wiring yet just stayed with my seat being complete and after some aggressive driving(hard cornering) and normal driving I don't notice any issues with the seat over time the seat may wear out alittle easier but as far as seat bottom comfort and stability I think it will work fine...will be finishing the rest of the seats over the next week or so then wiring them all in at the same time with the heater and oil sensor
I forgot to get pictures of the base while it was open but will have 3 more open

Sent from my Moto Z (2) using Tapatalk
 
21 - 24 of 24 Posts
Top